Acquiring Of The Gps Information - Panasonic Lumix DMC-TS3 Owner's Manual

Positioning is started once the GPS function is started, and acquired location name
information and other information can be stored in the recorded pictures.
Select [GPS Setting] from the [GPS/Sensor] menu.
Press 3/4 to select [ON] or [
Item
[ON]
[ ]
[OFF]
[INFO]
•
Exit the menu after it is set.
Note
•
Even if the receiving condition of the radio waves is excellent, it may take 2 to 3 minutes
to complete the positioning when performing positioning for the first time or when you
perform positioning after turning on the power again after turning the power off with the
[GPS Setting] set to [
• When [GPS Setting] is set to [ON], the GPS function will operate even when the power is
turned off. Electromagnetic waves from this unit may affect other electronic devices, so
set [GPS Setting] to [OFF] or [
unit onboard an airplane or inside a hospital etc.
• GPS status indicator
GPS status indicator
the
[GPS Setting] is set to [ON].
A GPS status indicator
Recording

Acquiring of the GPS information

•
Starts the GPS to receive radio waves.
•
It will continuously perform the positioning even if the power is turned
off when set to [ON].
•
It will perform the positioning only when the power is turned on.
• It will not perform the positioning when the power is turned off.
•
You can check or update the GPS information
•
For detail, refer to
] or [OFF].
] and turn the power of the unit off when you carry this
is lit during the positioning. Also, when
is lit with the power is turned off,
] and then press [MENU/SET].
Settings
—
"
Update the GPS information
- 84 -
(P44)
"
on P86.