Panasonic Lumix DMC-TS3 Owner's Manual page 175

Positioning is not possible.
•
[GPS Setting] is set to [OFF].
•
Radio waves from GPS satellites may not be received depending on the recording
environment, such as indoors or close to a building.
> It is recommended to use by holding the camera still for a while at an outdoor location clear
to the sky, with the antenna pointed upward.
GPS status indicator is lit while the power is turned off.
•
[GPS Setting] is set to [ON].
> Set [GPS Setting] to [OFF] or [
inside a hospital etc.
Positioning takes time.
•
It may take a few minutes the first time you use it or when it has not been used for a while.
•
Positioning is performed within 2 minutes normally, but since the position of the GPS satellites
change, it may take longer depending on the location or environment of the recording.
•
It will take longer for positioning in an environment where it is harder to receive the radio waves
from the GPS satellites.
Location name information is different from the place the picture was recorded
in.
•
Straight after the power is turned on, or when the GPS icon is not set to [
and location name information stored in the unit may differ significantly.
•
It can be changed to a different candidate before recording a picture when [
(P87)
Location name information is not displayed.
•
When a landmark etc. does not exist nearby or no information is registered in the database of
the unit, [---] is displayed.
> You can enter location names etc. with [Place-Name Edit] during the playback.
Others
About the GPS
(P84)
] when you turn the power off onboard an airplane or
(P83)
(P85)
- 175 -
(P83)
], current location
] is displayed.
(P126)