Table of Contents
Advertisement
Available languages
Available languages
•
To switch the appliance on, press the ON/OFF
button
1
, then turn the SmartSelect™ dial
desired setting.
•
To switch the appliance off, turn the SmartSelect™ dial to
off, then press the ON/OFF button.
NOTICE: Never leave the steam mop in one spot
on any surface for any period of time. Do not store
with a wet pad as this can damage your floor. Always
place the steam mop with the handle tube
upright position when stationary and make sure the
steam mop is turned off and unplugged when not
in use.
NOTICE: Always empty the water tank after use.
SmartSelect
Dial (Fig. A)
TM
The steam mop is equipped with a SmartSelect™ steam
dial
3
which shows various hard surface cleaning
applications. To change the application, turn the
SmartSelect™ steam dial until the correct operating mode
for your particular hard floor surface is selected.
NOTICE: The dial has an "off" position. There will be
no steam flow when the dial is turned to this position
NOTICE: For garments and carpet, set the dial to to
the Wood/Laminate setting.
NOTICE: Do not use on any unsealed hard floor
surfaces. Additionally, on surfaces that have been
treated with wax or some no wax floors, the sheen
may be removed by the heat and steam action. It
is always recommended to test an isolated area of
the surface to be cleaned before proceeding. We
also recommend that you check the use and care
instructions from the floor manufacturer.
Using the SmartSelect™ steam dial, choose from one of
the following applications. The steam mop will select
the correct volume of steam required for your particular
cleaning operation.
Steam Mop Cleaning (Fig. A)
1. Place a cleaning pad
21
loop' side facing up.
2. Lightly press it down onto the cleaning pad.
3. Plug the steam mop electric cord into the outlet.
4. Press the ON/OFF button
seconds for the steam mop to heat up.
5. Turn the SmartSelect™ steam dial
setting to activate the steam pump. After a few seconds
steam will start to come out of the steam floor head at
the rate corresponding to the SmartSelect™ dial setting.
NOTICE: If the system has been run dry it may take up
to 30 seconds to prime the system on first use.
3
to the
6
in the
on the floor with the 'hook &
1
. It takes approximately 15
3
to the desired
NOTICE: It takes a few seconds for steam to enter the
cleaning pad. The steam mop will now glide easily
over the surface to be cleaned.
6. Push and pull the steam mop slowly across the floor to
thoroughly steam clean each section.
7. When you have finished using the steam mop, turn
the SmartSelect™ steam dial to off, unplug the steam
mop, and wait until the steam mop cools down
(approximately five minutes).
Steam Glove (Fig. L–O)
WARNING: Always use the steam glove as shown in
Figure L, with your hand inside the protective glove.
WARNING: Never attempt to use the steam glove by
gripping it externally as shown in Figure M. This will
result in scalding.
WARNING: Avoid using the steam glove in tight
corners as shown in Figure N.
WARNING: Should a problem occur during use, use
the quick release tab
glove from your hand as shown in Figure O.
Figure L
Figure M
Figure N
Figure O
English
15
to quickly remove the steam
7
Advertisement
Table of Contents
