Titan PGD2000X Operator's Manual page 9

Refueling
•
Always turn the engine off and allow adequate time for it to cool before refueling. ONLY USE
UNLEADED FUEL WITH 86 OCTANE OR HIGHER.
•
NEVER refuel your driver with the engine hot, running, or in an unventilated area. Fuel vapors
are extremely flammable and can cause severe injury or death if ignited by a spark or
excessive heat from a hot engine.
•
Fill the tank on level ground and avoid spilling the fuel on the motor. Always allow any spilled
fuel to evaporate before restarting the engine.
•
Ensure the fuel cap is adequately tightened before restarting the engine.
Installing the Adapter Sleeve
• A 1" adapter sleeve is included with each PGD2000X Post Driver and a 2 ½" adapter sleeve is
included with each PGD3200X Post Driver.
•
To install the adapter sleeve, unscrew the barrel cap and slide the adapter sleeve into the
barrel. Replace the barrel cap, ensuring that the barrel cap gasket is still in place. See Figure 2.
Figure 2: Installing the adapter sleeve on a PGD3200X
Additional sleeve sizes are available for both the PGD2000X and PGD3200X Post Drivers.
9