Table of Contents
Advertisement
7. TRANSPORT
Tighten the set screw (10) to lock the rotary table.
Press the machine head (4) downwards and secure with the locking bolt (21).
Carry the equipment by the fixed saw table.
8. MAINTENANCE
Warning! Prior to any adjustment, maintenance or service work, disconnect the mains power plug!
General maintenance measures
Wipe chips and dust off the machine from time to time using a cloth. In order to extend the service life of
the tool, oil the rotary parts once monthly. Do not oil the motor.
When cleaning the plastic do not use corrosive products.
Cleaning the moving saw blade guard safety device (5)
Always check the saw blade guard for debris before using the machine.
Remove old sawdust and splinters using a brush or similar tool.
Brush inspection
Check the carbon brushes after the first 50 operating hours with a new machine, or when new brushes
have been fitted. After carrying out the first check, repeat the check every 10 operating hours.
If the carbon is worn to a length of 6 mm, or if the spring or contact wire are burned or damaged, it is
necessary to replace both brushes. If the brushes are found to be usable following removal, it is possible to
reinstall them.
When servicing the carbon brushes, open the two latches counter clockwise (as shown in Figure 20). Then
remove the carbon brushes.
Replace the carbon brushes in the reverse order.
9. STORAGE
Store the device and its accessories in a dark, dry and frost-proof place that is inaccessible to children.
The optimum storage temperature is between 5 and 30˚C.
Store the electrical tool in its original packaging.
Cover the electrical tool in order to protect it from dust and moisture.
Store the operating manual with the electrical tool.
21
Advertisement
Table of Contents
