Table of Contents
Advertisement
3.0
Configuring and Mounting the Drive
This section contains the specifications and instructions for configuring and mounting the drive.
3.1
Handling and Static-Discharge Precautions
After unpacking, and before installation, the drive may be exposed to potential handling and electrostatic discharge (ESD)
hazards. Observe the following standard handling and static-discharge precautions.
• Keep the drive in the electrostatic discharge (ESD) bag until users are ready for installation to limit the
drive's exposure to ESD.
• Before handling the drive, put on a grounded wrist strap, or ground onerself frequently by touching the
metal chassis of a computer that is plugged into a grounded outlet. Wear a grounded wrist strap
throughout the entire installation procedure.
• Handle the drive by its edges or frame only.
CAUTION
• The drive is extremely fragile—handle it with care. Do not press down on the drive top cover.
• Always rest the drive on a padded, antistatic surface until users mount it in the computer.
• Do not touch the connector pins or the printed circuit board.
• Do not remove the factory-installed labels from the drive or cover them with additional labels. Removal
voids the warranty. Some factory-installed labels contain information needed to service the drive. Other
labels are used to seal out dirt and contamination.
3.2
Configuring the Drive
Each drive on the Serial ATA interface connects in a point-to-point configuration with the Serial ATA host adapter. There is no
master/slave relationship because each drive is considered a master in a point-to-point relationships. If two drives are
attached on one Serial ATA host adapter, the host operating system views the two devices as if they were both "masters" on
two separate ports. Both drives behave as if they are Device 0 (master) devices.
3.2.1
Serial ATA Cables and Connectors
The Serial ATA interface cable consists of four conductors in two differential pairs, plus three ground connections. The cable
size may be 30 to 26 AWG with a maximum length of one meter (39.37 in). Refer to
Either end of the SATA signal cable can be attached to the drive or host.
For direct backplane connection, the drive connectors are inserted directly into the host receptacle. The drive and the host
receptacle incorporate features that enable the direct connection to be hot pluggable and blind mateable. For installations
which require cables, users can connect the drive as shown in
Figure 2 Attaching SATA Cabling
Signal connector
Signal cable
Power cable
Each cable is keyed to ensure correct orientation. Seagate Laptop Thin SSHD SATA drives support latching SATA
connectors.
Seagate Laptop Thin SSHD SATA Product Manual, Rev. J
Power connector
Table 8
.
Figure 2
for connector pin definitions.
19
Advertisement
Table of Contents
