Quick Starts - Panasonic SDR-S7 Basic Operating Instructions Manual

Rotate the mode dial to motion picture recording/playback, still picture
recording/playback or turning the unit OFF.

Quick starts

Quick starts are available when the mode is set to [
When [QUICK START] is [ON], the unit responds as follows to LCD monitor
operations:
LCD monitor
operation
When opened
When closed
＊ The unit consumes about half as much power as when recording is stopped.
Setting [QUICK START]
• [QUICK START] is [ON] at the time of purchase.
● The quick start standby is cancelled and the unit turns OFF (status indicator
out) in the following situations.
• When quick start standby mode continues for more than about 5 minutes
• When the mode dial is rotated
● When white balance is set to [
source differs from that prior to quick starting, because automatic adjustments
are performed. (However, automatic adjustments are not performed when
using the Colour night view function.)
● Starting may require more time than usual if the unit is impacted.
● Zoom magnification becomes 1x after quick starts.
● If [POWER SAVE] is set to [5 MINUTES] and the unit automatically goes on
quick start standby, close and reopen the LCD monitor.
Unit response
Shooting can start in approx. 0.6 second.
The unit goes on quick start standby
], quick starts require more time if the light
] and [ ].
.
＊
Make settings from the
menus. (P.16)
→[SETUP]→
[QUICK START]→[ON]
(To turn OFF, select [OFF].)
Status
indicator
Lit red
Flashing green
15
VQT1R57 (ENG)