Table of Contents
Advertisement
Rotate the mode dial to motion picture recording/playback, still picture
recording/playback or power OFF.
Quick starts
Quick starts are available when the mode is set to [
When [QUICK START] is [ON], the unit responds as follows to LCD monitor
operations:
LCD monitor
operation
When opened
When closed
＊ The unit consumes about half as much power as when recording is stopped.
Setting [QUICK START]
•
[QUICK START] is [ON] at the time of purchase.
●
The quick start standby is canceled and power shuts OFF (status indicator
out) in the following situations.
•
When quick start standby mode continues for more than about 5 minutes
•
When the mode dial is rotated
●
When the white balance has been set to the automatic adjustment (during
automatic recording or when it is set to [
and quick start has been initiated, quick start may take longer if a different
light source is used from the one prior to initiating quick start: This happens
because the automatic adjustments are performed again.
●
Starting may require more time than usual if the unit is impacted.
●
Zoom magnification becomes 1x after quick starts.
●
If [ECONOMY] (P.92) is set to [5 MINUTES] and the unit automatically goes
on quick start standby, close and reopen the LCD monitor.
Unit response
Shooting can start in approx. 0.6 seconds.
The unit goes on quick start standby
] and [ ].
.
＊
Select settings from the
menus. (P.26)
→[SETUP]→
[QUICK START]→[ON]
(To turn OFF, select [OFF].)
] during manual recording)
Status
indicator
Lit red
Flashing green
25
LSQT1426
Advertisement
Table of Contents
