Techpro CVIPTZ-EL2L12X User Manual page 11

Open the transparent enclosure, there are two dial switch buttons on the PCB of one side of the speed
dome (There are labels.). You can use them to set speed dome protocol, baud rate, address and etc.
See Figure 2-2 .
After setup, you need to click on-off button or go to the OSD menu to select restart option to
reboot the device to activate new setup.
2.2.2 Baud Rate and Parity
Please note the IR speed dome can automatically recognize the industrial standard protocol,
PELCO-D. PELCO-P. Usually you do not need to set the protocol.
The interface is shown as in Figure 2-3.
Please refer to the baud rate sheet for detailed information.
1
OFF
ON
OFF
ON
Figure 2-2
Figure 2-3
2 Baud Rate
OFF 9600bps
OFF 4800bps
ON 2400bps
ON 1200bps
4