Setting The Home Zone; Synchronizing The Source And Zone Volume Levels; Adjusting The Power-On Volume Limit; Maintaining Individual Zone Volume Levels - Garmin FUSION APOLLO MS-WB675 Manual

Setting the Home Zone

The home zone is the speaker zone that you adjust by default when you turn the dial on the remote control.
1 Select > SETTINGS.
2 Select the name of the remote control you plan to use with this stereo.
3 Select ASSIGN HOME ZONE.
4 Select a zone.

Synchronizing the Source and Zone Volume Levels

You can synchronize the volume levels on one or all zones with some source devices, such as a Bluetooth,
AirPlay, or UPnP source.
1 Select > SETTINGS.
2 Select the name of the stereo.
3 Select ZONE > PHONE VOLUME SYNC.
4 Select a zone or ALL.
When you adjust the volume on the connected source, the volume on the selected zone is also adjusted.

Adjusting the Power-On Volume Limit

By default, when you turn on the stereo, the system automatically reduces the volume to level 12 if it was louder
than that when you turned it off. You can adjust this limit if you want to retain a louder volume or limit to a lower
volume when you turn on the stereo.
NOTE: This setting affects all zones on the stereo.
1 Select > SETTINGS.
2 Select the name of the stereo.
3 Select ZONE > POWER ON VOLUME LIMIT.
4 Adjust the volume limit.

Maintaining Individual Zone Volume Levels

If you adjust the volume levels of individual zones so that some zones are louder than others, the individual
zone volume settings are all affected when you adjust the volume for ALL zones. By default, if you adjust the
volume for ALL to 00, this sets of the volume levels for all zones to 00 and resets all individual zone volume
adjustments. You can enable the KEEP VOLUME RATIOS option to retain individual zone volume adjustments
when you adjust the volume for ALL to 00.
NOTE: This setting applies to volume adjustments on the stereo or a connected Apollo ERX400 remote control
only. If you adjust the volume on the stereo using a connected chartplotter or NRX remote control, the volume
levels will still be reset.
TIP: For the best results when enabling this setting, you should set the power-on volume limit to 24
the Power-On Volume Limit,
1 Select > SETTINGS.
2 Select the name of the remote control.
3 Select KEEP VOLUME RATIOS.

Enabling Automatic Volume Adjustment Based on Speed

1 Select > SETTINGS.
2 Select the name of the stereo.
3 Select ZONE > SPEED VS VOLUME > ENABLED
4 If needed, update the settings to select the speed source
26
page 26).
(Automatic Volume Control Settings,
(Adjusting
page 27).
General Settings