Send Data To Sd Card; Communication Port Setting - Yaesu ADMS-15 Instruction Manual

Send Data to SD card

Memories and settings from the ADMS-15 PC programmer may be transferred to the microSD memory
card.
Data cannot be sent to the microSD memory card until the information is read from the
FTM-200D to the ADMS-15 PC programmer. See "Be sure to read the transceiver informa-
tion data before using ADMS-15" (Page 8) for more information.
1. Insert a microSD memory card to write data for transfer from PC to FTM-200DR/DE.
2. Click [Send Data to SD card] in the "Communications" menu, then select the data area to write
from the following.
ALL / MEMORY / SETUP
3. Select the file in the following folder of the microSD card drive according to the selected area.
ALL : "CLNFTM200D.dat" file in the "FTM-200D" folder - "BACKUP" folder
MEMORY : "MEMFTM200D.dat" file in the "FTM-200D_MEMORY-CH" folder
SETUP : "SYSFTM200D.dat" file in the "FTM-200D" folder - "BACKUP" folder
Please note that the FTM-200DR/DE cannot read the data from the SD card if you
change the save folder or file name.
4. Click the [Save] button.
5. Click the [OK] button.
To transmit previously created data to the microSD memory card, click [Open] in the "File"
menu and open the desired file before performing the Send Data to SD card operation above.

Communication port setting

This procedure is not necessary when exchanging data using a micro SD card.
1. Connect the FTM-200DR/DE to a computer (Refer to
the "Connect the FTM-200DR/DE and the PC").
2. Execute the ADMS-15 (Refer to the "Execute the
ADMS-15").
3. From the menu bar, select "Communications" menu,
and then click on the "COM port Settings".
4. Click [▼] in the "Serial Port Selection" column and
click the COM port connected to the FTM-200DR/DE.
5. Click [Determine].
12