Send Data To Ftm-6000 - Yaesu ADMS-13 Instruction Manual

This template and configuration data may be saved to the computer hard drive, using the
"Save" or "Save as" commands in the "File" menu.

Send Data to FTM-6000

This command downloads the ADMS-13 data from the computer to the FTM-6000R/E.
Click the "Save Data to FTM-6000R/E" parameter in the "Communications" menu. The transmission
procedure screen will open.
To load a previously created data file to the FTM-6000R/E, click the "Open" parameter in the
"File" menu, and open the desired file before performing the send data operation above.
1. Connect the PC connection cable SCU-20 between the FTM-6000R/E and the computer.
2. Follow the on-screen instructions to transmit data to the FTM-6000R/E.
3. After the data transmission completes, "Completed" will appear on the computer display, and click
the [Close] button.
4. The FTM-6000R/E will automatically re-start in accordance with the set data.
• Never disconnect the programming cable while data transmission is in progress.
• Pay careful attention to the power cable and the connections to the FTM-6000R/E and the
computer, so as not to lose the power during data reception/transmission.
12