With The Ftm-200Dr/De); Get Data From Sd Card - Yaesu ADMS-15 Instruction Manual

Communications (Data communication with the FTM-200DR/DE)

Get Data from SD card

This command imports the settings data from the microSD memory card to the ADMS-15 PC program-
mer, and creates a new data file.
1. Insert the microSD memory card with the saved data from FTM-200DR/DE to the computer.
2. Click [Get Data from SD card] in the "Communications" menu, then select the data area to read
from the following.
ALL / MEMORY / SETUP
3. Select the file in the following folder of the microSD card drive according to the selected area.
ALL : "CLNFTM200D.dat" file in the "FTM-200D" folder - "BACKUP" folder
MEMORY : "MEMFTM200D.dat" file in the "FTM-200D_MEMORY-CH" folder
SETUP :
"SYSFTM200D.dat" file in the "FTM-200D" folder - "BACKUP" folder
4. Click [Open].
5. Click [OK].
When the data transfer is complete, the template screen which was imported from the FTM-200DR/DE
via the microSD memory card will appear on the ADMS-15 screen.
This template and configuration data may be saved to the computer hard drive, using the "Save"
or "Save as" commands in the "File" menu.
● The folder configuration of the micro-SD card
The parameters of each function are stored in the following folders.
(root)
FTM200D
FTM200D_MEMORY-CH: Memory channel data (MEMFTM200D.dat) : MEMORY
PHOTO: image data (M+(RADIO ID)+xxxxx.jpg)
QSOLOG: Message data
VOICE: Voice recording data (yymmddhhmmss.wav)
BACKUP: Various settings data
GPSLOG: GPS Log data (yymmddhhmmss.log)
(CLNFTM200D.dat) : ALL
(SYSFTM200D.dat) : SETUP
11