Table of Contents
Advertisement
Unit Installation
4.
UNIT INSTALLATION
The instructions and guidelines provided in this section cover hardware installation topics, such as mounting
options and supplying power to the unit. These instructions are presented as follows:
•
Mounting Options on page 19
•
Supplying Power to the Unit on page 22
For information on configuring a specific application, refer to the configuration guides provided on the
ADTRAN's Knowledge Base
article 2219).
To prevent electrical shock, do not install equipment in a wet location or during a
lightning storm.
The NetVanta 644 is intended to be to be installed, maintained, and serviced by qualified
service personnel only and should be installed in a restricted access location as described
in UL/IEC 60950-1.
Remove all power sources prior to servicing the unit.
Ethernet cables are intended for intra building use only. They should not be run outside
the building.
Tools Required
The customer-provided tools required for the hardware installation of the NetVanta are:
•
Ethernet cables
•
Network cables (module dependent)
•
Phillips-head screwdriver
•
Drill and drill bit set (wallmount applications only)
To access the CLI of the NetVanta, you will also need a PC with terminal emulation
software and a console port cable. Instructions on how to access the CLI are available in
the quick start guide shipped with your unit or online at
18
or the
AOS Command Reference Guide
Copyright © 2011 ADTRAN, Inc.
NetVanta 640 Series Hardware Installation Guide
(ADTRAN's Knowledge Base
ADTRAN's Knowledge
Base.
61700144G1-34A
Advertisement
Table of Contents
