Advertisement
4-2. Vertical adjustings
PIR area adjustment
1
Vertical: 0° to -20°
Caution
Do not use the vertical angle adjustment of the main unit other than adjusting
the detection area surface to be parallel to the ground inclination.
Parallel
4-3. PIR/VCA settings
Refer to the InSight VCA manual for details on PIR and VCA area settings.
InSight VCA manual
https://navi.optex.net/manual/50426/en/?type=VCAmanual
4-4. PIR area masking
The default settings are 12.0 m (40') 120° wide.
If no masking of the detection area is required,
proceed to the next item.
INS-QXI-ST Full manual
https://navi.optex.net/manual/50426/en/?type=installationinstructions
4-6. Put on the back cover
Adjust the detection range
Step
5
Checking
Walk test: Check the detection area by walking around the area.
1
System check: Check the image at the time of detection on the monitoring portal.
2
Camera angle adjustment
2
Loosen the screw to adjust camera angle
Angle can be adjusted with either left or right screw.
NOTE
It is recommended that use the Camera angle at 25° to 35°
since camera images may appear white and blurred in dark scenes.
Caution
If the vertical angle of the camera is to be adjusted, adjustment of this
sections must be matched to ensure the best performance of the sensor.
4-5. Switch settings
Do not move the
mirror
nor
3
20°min.
Default
30°
35°max.
Super High
Middle
Default
Future use
PIR sensitivity
ON
Alarm output
N.O.
LED
ON
Default
* Alarm output must be kept to N.C.
N.O. setting may cause unstable performance.
PCB
from the factory settings as Pet alley cannot be set.
High
Low
OFF
N.C. Do not change *
OFF
Caution
Advertisement
