INS-QXI-ST
INS-QXI-ST
VISUAL VERIFICATION PIR CAMERA
<< Contents >>
Before installation
- Manufacturer's statement
- Parts identification
- Accessories
- CHeKT account
Step
1
Installation
Enable
DHCP
Disable
2
IP address settings
InSIght Camera manual
https://navi.optex.net/manual/50426/en/?type=cameramanual
3
Device registration to CHeKT portal
4
Camera angle and PIR area settings
5
Checking
Others
- Specifications
- Dimensions
- Detection area
- Compliance
- How to reset to the factory default
series
Before installation
- Manufacturer's statement
Page
1
Warning
Caution
2
Warning
Disassemble
Intentional watering
- Parts identification
CHeKT support
https://support.chekt.com
3
4
- Accessories
Mounting screws
- CHeKT account
If you do not have a CHeKT account, request a dealer account by visiting the
"CHeKT dealer" , before Step 3. Refer to the "CHeKT support" for more details.
INSTALLATION INSTRUCTIONS
https://navi.optex.net/manual/50426
•
This "Quick Guide" is the part of the entire installation instructions
that guides the installation procedures for installers.
•
Get the full information of the installation instructions from the web site.
•
If you need a guide to the operation of the whole system, please
consult the installer of the entire system.
Failure to follow the instructions provided with this indication and
improper handling may cause death or serious injury.
Failure to follow the instructions provided with this indication and
improper handling may cause injury and/or property damage.
Prohibition
Recommendation
Destroy
modify
PIR detector
PIR cover
Camera unit
4 x 20 mm
T20 Torx wrench
CHeKT dealer
www.chekt.com/registration
1
59-3061-1 2212-27
Quick Guide
Full information is available at
Special attention is required to the
NOTE
section of this symbol.
Caution
Mounting on
an unstable
wall
Bracket angle adjusting screw
Back cover
Camera angle adjusting screw
Waterproof cap
for LAN connection
PIR area masking strips
CHeKT support
https://support.chekt.com
Mounting plate