Cleaning Under The Machine; Storing The Machine In The Vertical-Stow Position - Toro STRIPE 21620 Operator's Manual

Cleaning the Machine
Service Interval: After each use

Cleaning under the Machine

Service Interval: After each use
For best results, clean under the machine soon after
you have completed mowing.
1. Shut off the machine and remove the battery
pack and the safety key.
2. Lower the machine to its lowest cutting-height
setting.
3. Set the machine in the vertical-stow position;
refer to Storing the Machine in the Vertical-Stow
Position (page 21).
4. Using a brush or broom, clean any debris away
from the underside of the machine.
Important:
Do not use water to clean the
machine; water may damage electrical
components.
5. Clean the grass box.
Storing the Machine in the
Vertical-Stow Position
You can store your machine in the vertical position to
minimize storage space.
DANGER
The vertical-stow position exposes the bottom
of the machine.
• Remove the battery pack and the
electric-start button before moving the
machine into the vertical-stow position.
• Do not transport the machine in the
vertical-stow position.
• Do not attempt to start the machine in the
vertical-stow position.
1. Remove the battery pack from the machine.
2. Ensure that the cutting-height setting on the
machine is 44 mm (1-3/4 inches) or higher; if
it is not, raise it; refer to
Height (page 15).
3. Disengage the handle locks
4. Fold the handle fully forward.
Important:
Route the cables to the outside
of the handle locks as you fold the handle.
5. Engage the handle locks.
6. Lift the front of the machine by the handle and
move it into a storage space
21
Adjusting the Cutting
(Figure 20).
(Figure 19).
Figure 19
g410317