Laura Ashley CLIFTON Bed Assembly Instructions

Table of Contents

Download this manual

Thank you for purchasing this product. Please read the instructions carefully before use to ensure safe

and satisfactory operation of this product.

Please check the pack contents before you begin. A full checklist of components is given in this leaflet. If

any components are missing, please contact the retailer from whom you bought this product.

Safety Advice and Assembly Recommendations

Do not stand or lean on this product.

Make sure the area is clear when unpacking and positioning this product.

This product is heavy; it should be assembled as near as possible to the point of use.

Take care when lifting to avoid personal injury and /or damage to the product.

Keep small children/pets away from the assembly area. This product has small component parts that

are a choking hazard.

Make sure you assemble this product correctly as per the instructions, and ensure all fittings are

tight.

A minimum of two people is required to lift the bed into its position.

We recommend that the packaging is used to protect the surfaces during assembly.

CLIFTON Bed

Table of Contents

Do you have a question about the CLIFTON Bed and is the answer not in the manual?

Page 1 CLIFTON Bed Thank you for purchasing this product. Please read the instructions carefully before use to ensure safe and satisfactory operation of this product. Please check the pack contents before you begin. A full checklist of components is given in this leaflet. If any components are missing, please contact the retailer from whom you bought this product.
Page 2 Fittings and parts checklist Bolt M8X30 x 12 Allen Key x 1 Screw Ø 3.5 x25 x 12 Dowel D8X25 x 8 Step by step assembly instructions A minimum of two people is required to assemble this product. Step One Attach one side rail to the headboard.
Page 3 Step Three - Attach 2 of the adjustable support legs to the centre rail. Attach by screwing clockwise. Step Four - Place the centre rail into position by pressing the metal brackets onto each other. Step Five - Place 8 x wood dowels No.C into the pre-drilled positions on the side rails. - Place the slats between the side rails and the centre rail.
Page 4 - To compensate for uneven floors, adjust the middle support legs, as necessary. Leave a small gap between a foot and a floor. The foot should only touch the floor when sleeping in a bed. Care and Maintenance: please refer to Laura Ashley Care Guide.