Connecting The Ductwork; Replacing The Bottom Trim - Electrolux Icon E40PV100FS Installation Manual

Installation

CONNECTING THE DUCTWORK

LOWER
FLUE
RETAINING
SCREWS
8" ROUND
METAL
Figure 14
DUCT
MOUNTING
SCREWWS
(3.9 x 9.5 mm)
Figure 15

REPLACING THE BOTTOM TRIM

Figure 16
1 Use 8" round metal duct to connect the discharge collar on the hood to
the ductwork above.
2 Use duct tape to make all joints secure and air tight.
3 Remove the two temporary retaining screws from the lower flue and set
it in place on the hood.
4 Secure decorative flue to hood with two mounting screws (3.9 x 9.5mm).
pan head mounting screws.
1 Remove the four (4) screws from the inside of the hood.
2 Remove the trim by pulling downward.
3 Slide the new trim upward into hood.
4 Replace the four screws inside hood.