Environmental Considerations; Panel Mounting - Vision OPLC V350-35-TA24 Installation Manual

Environmental Considerations

Do not install in areas with: excessive or conductive dust, corrosive or flammable gas,
moisture or rain, excessive heat, regular impact shocks or excessive vibration,
in accordance with the standards given in the product's technical specification sheet.
Do not place in water or let water leak onto the unit.
Do not allow debris to fall inside the unit during installation.
Ventilation: 10mm space required between controller's top/bottom edges & enclosure walls.
Install at maximum distance from high-voltage cables and power equipment.
For UL listed module, in order to meet the UL508 standard, panel-mount this device on the
flat surface of a Type 1 enclosure.
Mounting
Dimensions
*Note that for V350-J/V350-JS modules those dimensions are 6.7 mm (0.26").

Panel Mounting

Before you begin, note that the mounting panel cannot be more than 5 mm thick.
1. Make a panel cut-out measuring 92x92 mm (3.622"x3.622").
1. Slide the controller into
the cut-out, ensuring that
the rubber seal is in
place.
2. Push the mounting
brackets into their slots
on the sides of the panel
as shown in the figure to
the right.
3. Tighten the bracket's
screws against the
panel. Hold the bracket
securely against the unit
while tightening the
screw.
2
V350-35-TA24, V350-J-TA24, V350-S-TA24, V350-JS-TA24 Installation Guide
Unitronics