Storage; Troubleshooting; Fluid Compatibility - FILL-RITE 902V Series Installation And Operation Manual

Storage

If your dispenser is to be stored for a period of time, clean it thoroughly. This will help protect the dispenser from
possible damage.
Troubleshooting Guide
The following troubleshooting guide is designed to help you with basic diagnostics and repairs if you should
encounter abnormal service from your FR902 series dispenser. We recommend you use only genuine Fill-Rite parts.
These parts, and additional service information is available through your authorized Fill-Rite dealer.
Further troubleshooting information can be found in your pump manual. If you need additional assistance, please
contact us at 1 (800) 720-5192 (M-F 8 AM–5 PM ET).
Concern Possible Cause
Dispenser miscalibrated
Counter
Air in lines or dispenser chamber Check line seals and joints for leakage; seal leaks appropriately.
inaccurate
Measuring gears or disc
are sticking
Fluid leak Dirty or damaged seal or gasket
Clogged meter chamber
Low flow
capacity Plugged filter
Plugged pump
Meter body
Excess line pressure
cracks
Nutating Disc Sudden high pressure fluid
Broken hitting disc

Fluid Compatibility

The FR902 Series dispensers are compatible ONLY with the following fluids:
• Diesel Fuel • Gasoline & Gasoline / Alcohol blends (up to 10% ethanol)
• Fuel Oil • Lubricating Oil (up to 60W lubricating oil; not temperature dependant)
CAUTION
If in doubt about compatibility of a specific fluid, contact supplier of fluid to check for
any adverse reactions to the following wetted materials:
Ryton
fillrite.com
| 902V SERIES CABINET DISPENSER
Recommended Repair
Check calibration and recalibrate as necessary
(directions on page 6).
Clean or replace internal dispenser components as necessary.
Clean seal or gasket and seat, replace seal or gasket
as necessary.
Clean meter chamber; clean or replace screens and filters
in piping.
Replace filter element.
Inspect and clean pump as necessary.
Install pressure relief valve so high pressure bleeds back to
the tank. Replace cracked meter body.
Avoid surge flows by installing a shutoff valve on outlet of
dispenser; install dispenser as close to the pump as possible,
keep piping full of liquid. Replace meter chamber assembly.
, Aluminum, Stainless Steel, Fluorocarbon, Buna N, Polyester
®
INSTALLATION AND OPERATION MANUAL
7