Midea MDW 10E4 S User Manual page 70

Table of Contents

Advertisement

Available languages

Available languages

Water Softener
The water softener must be set manually, using the water hardness dial.
The water softener is designed to remove minerals and salts from the water, which would
have a detrimental or adverse effect on the operation of the appliance.
The more minerals there are, the harder your water is.
The softener should be adjusted according to the hardness of the water in your area.
Your local Water Authority can advise you on the hardness of the water in your area.
Adjusting salt consumption
The dishwasher is designed to allow for adjustment in the amount of salt consumed
based on the hardness of the water used. This is intended to optimise and customise
the level of salt consumption.
Please follow the steps below for adjustment in salt consumption.
1. Open the door, switch on the appliance;
2. Within 60 seconds after the appliance was switched on press the Program
button for more than 5 seconds to enter the water softener setting mode.
3. Press the Program button again to select the proper setting according to your
local water hardness, the setting will change in the following sequence:
H3->H4->H5->H6->H1->H2->H3;
4. Without operation in 5 seconds or press the Power button to complete the setup
and exit the setup mode.
WATER HARDNESS
German
French
dH
fH
0 - 5
0 - 9
6 - 11
10 - 20
12 - 17
21 - 30
18 - 22
31 - 40
22 - 28
23 - 34
41 - 60
29 - 42
35 - 55
61 - 98
43 - 69
1 dH=1.25
Clarke=1.78 )
The factory setting: H3
1)
Every cycle with a regeneration operation consumes additional 2.0 litres of water, the
energy consumption increases by 0.02 kWh and the program extents by 4 minutes.
British
Mmol/l
Clarke
0 - 6
0 - 0.94
H1: Rapid Light bright
7 - 14
1.0 - 2.0
H2: 90 min Light bright
15 - 21
2.1 - 3.0
H3: Rapid, 90 min Light bright
3.1 - 4.0
H4: ECO Light bright
4.1 - 6.0
H5: ECO, Rapid Light bright
6.1 - 9.8
H6: 90 min, ECO Light bright
fH=0.178mmol/l
Water softner level
26
Regeneration occurs
every X program
1)
sequence
No regeneration
10
5
3
2
1
Salt
consumption
(gram/cycle)
0
9
12
20
30
60

Advertisement

Chapters

Table of Contents
loading

Table of Contents