Regulatory Compliance Information; Eu Declaration Of Conformity - 70mai X200 User Manual

The eMMC (Embedded Multi Media Card) is built in the
●
dash cam for storage. You can find the memory capacity
information on the label of the dash cam and product
box.
Install this dash cam correctly, and do not block the
●
driver's line of sight, nor block the vehicle's airbag, in
order to avoid product failure or personal injury.
Use the included car charger, power cord, and other
●
accessories in order to avoid product failure due to non-
conformance. We shall not be held liable for any loss or
damage caused by the use of a non-genuine car charger
or power cord.
The dash cam is equipped with a built-in battery that
●
cannot be removed. Do not disassemble the dash cam.
Do not expose batteries or battery packs to sunlight,
fire, or environments where the ambient temperature is
extreme heat. There is a risk of explosion if the battery is
incorrectly installed, therefore only use and replace with
the same or an equivalent type of battery.
Keep the dash cam away from water drops or splashes.
●
Keep the device dry to avoid battery failure.
If the battery becomes deformed, swollen, or starts
●
leaking during use or storage, stop using the dash cam
immediately in order to avoid safety issues, and contact
after-sales service.
Never wash the dash cam with chemical solvent or
●
cleaner.
Keep the dash cam away from any strong magnetic fields,
●
as they may cause damage to the dash cam.
Do not use the dash cam in environments with
●
temperatures over 60°C or below -10°C.
After working for a period of time, the case temperature
●
of the dash cam will rise, please be careful when
touching it.
Only use this dash cam within the scope permitted by
●
law.

Regulatory compliance information

WEEE information
All products bearing this symbol are waste
electrical and electronic equipment (WEEE as
in directive 2012/19/EU) which should not be
mixed with unsorted household waste. Instead,
you should protect human health and the
environment by handing over your waste equipment
to a designated collection point for the recycling of
waste electrical and electronic equipment, appointed
by the government or local authorities. Correct disposal
and recycling will help prevent potential negative
consequences to the environment and human health.
Please contact the installer or local authorities for more
information about the location as well as terms and
conditions of such collection points.

EU declaration of conformity

The manufacturer hereby, declares that
this equipment is in compliance with the
applicable Directives and European Norms, and
amendments. The full text of the EU declaration
of conformity is available at the following internet address:
https://help.70mai.asia/1193.html
04