Samsung SINGLE CNH ZDK Series Technical Data Book page 65

Installation
Moving the outdoor unit with wire rope
1 Before carrying the outdoor unit, fasten two wire ropes
of 26.25 ft (8m) or longer, as shown in the figure.
2 To prevent damages or scratches effectively, insert a
piece of cloth between the outdoor unit and the ropes.
3 Move the outdoor unit.
Fixing the outdoor unit in place
Install the outdoor unit on a rigid and stable base to prevent
disturbance from any noise caused by vibration. When
installing the unit on tall stands or in a location exposed to
strong winds, fix the unit securely to the ground or structure.
1 Position the outdoor unit so that the air flow is directed
towards the outside, as indicated by the arrows on the
top of the unit.
2 Attach the outdoor unit to the appropriate support
using anchor bolts.
• The ground wire for the telephone line cannot be
used to ground the air conditioner.
3 DIf the outdoor unit is exposed to strong winds, install
shield plates around the outdoor unit, so that the fan
can operate correctly.
NOTE
• Install provided rubber legs to prevent vibration and noise.
Wire rope
Plate protection cloth
Wire rope
Plate protection cloth
AC018BXADCH
Anchor bolt hole
26.02(661)
34.65(880)
AC024/030/036/042/048BXADCH
Anchor bolt hole
24.41(620)
37.01(940)
CAUTION
• Install a drain outlet at the lowest end around the base
for outdoor unit drainage
• When installing the outdoor unit on the roof,
waterproof the unit and check the ceiling strength.
Optional: Fixing the outdoor unit to a wall with a rack
Designed to cut off residual vibration from outdoor
unit to rack. (not supplied with product)
Anchor bolt
Base surface
Soft rubber designed to cut off vibration from rack
to wall. (not supplied with product)
• Install a proper grommet in order to reduce noise
and residual vibration transferred by the outdoor unit
towards the wall.
[Unit : inch(mm)]
[Unit : inch(mm)]