Samsung SINGLE CNH ZDK Series Technical Data Book page 63

Installation
• Install the unit in a place where water can drain
smoothly.
• If you have any difficulty finding installation location
as prescribed above, contact your manufacturer for
details.
• Consider that the salinity particles clinging to the
external panels should be sufficiently washed out. Be
sure to clean sea water and dust from the outdoor unit
heat exchanger and apply a corrosion inhibitor on it at
least once a year.
• Because the residual water at the bottom of the
outdoor unit significantly promotes corrosion, make
sure that the slope does not disturb drainage.
– Keep the floor level so that rain does not
accumulate.
– Be careful not to block the drain hole due to foreign
substance.
• Check the condition of the product periodically.
– Check the installation site every 3 months and
perform anti-corrosion treatment such as R-Pro
supplied by SAMSUNG (Code : MOK-220SA) or
commercial water repellent grease and wax, etc.,
based on the product condition.
– When the product is to be shut down for a long
period of time, such as off-peak hours, take
appropriate measures like covering the product.
• If the product installed within 1640.4 ft of seashore,
special anti-corrosion treatment is required.
for further details.
CAUTION
• In areas with heavy snow fall, piled snow could block
the air intake. To avoid this incident, install a frame
that is higher than estimated snow fall. In addition,
install a snow-proof hood to avoid snow from piling on
the outdoor unit.
Estimated snow
fall
Snow-proof hood
Frame
Ground
Outdoor unit dimensions
AC018BXADCH
12.20 (310)
34.65 (880)
1.93 (49)
AC024BXADCH, AC030BXADCH
37.01 (940)
AC036BXADCH, AC042BXADCH, AC048BXADCH
37.01 (940)
Unit : inch (mm)
26.02 (661)
24.41 (620)
24.41 (620)