Choosing The Installation Location; Installation Location Requirements - Samsung SINGLE CNH ZDK Series Technical Data Book

Installation

Choosing the installation location

Installation location requirements

• Do not place the outdoor unit on its side or upside
down. Failing to do so may cause the compressor
lubrication oil to run into the cooling circuit and lead
to serious damage to the unit.
• Install the unit in a well-ventilated location away from
direct sunlight or strong winds.
• Install the unit in a location that would not obstruct
any passageways or thoroughfares.
• Install the unit in a location that would not
inconvenience or disturb your neighbors, as they could
be affected by the noise or the airflow coming from
the unit.
• Install the unit in a location where the pipes and the
cables can be easily connected to the indoor unit.
• Install the unit on a flat, stable surface that can
withstand the weight of the unit. Otherwise, the unit
can generate noise and vibration during operation.
• Install the unit so that the air flow is directed towards
the open area.
• Maintain sufficient clearance around the outdoor unit,
especially from a radio, computer, stereo system, etc.
Control
Stereo Computer etc
Air Guide Duct (This product is not provided by Samsung)
Fuse
Indoor Unit
4.92 ft(1.5m) or more
4.92 ft(1.5m) or more
11.81inch(300mm)
Outdoor Unit
7.87 inch(200mm)
CAUTION
• You have just purchased a system air conditioner and it
has been installed by your installation specialist.
• This device must be installed according to the national
electrical rules.
• If your outdoor unit exceeds a net weight of 132.2 lb(60 kg),
do not install it on a suspended wall, but stand it on a floor.
• The reliability of our product cannot be guaranteed
under conditions of "A" or less.
Outdoor Model
• When installing the outdoor unit at the seaside, make
sure that it is not directly exposed to sea breeze. If you
cannot find an adequate place free from direct sea
breeze, construct a protection wall or a protective fence.
– Install the outdoor unit in a place (such as near buildings
etc.) where it can be prevented from sea breeze. Failure
to do so may cause a damage to the outdoor unit.
Sea breeze
Sea
Outdoor Unit
• If you cannot avoid installing the outdoor unit at the seaside,
construct a protection wall around to block the sea breeze.
• Construct a protection wall with a solid material such
as concrete to block the sea breeze. Make sure that the
height and the width of the wall are 1.5 times larger
than the size of the outdoor unit. Also, secure a space
larger than 27.6 inch(700mm) between the protection
wall and the outdoor unit for exhausted air to ventilate.
Sea breeze
Sea
CAUTION
• Depending on the condition of the power supply,
unstable power or voltage may cause malfunction of
parts or control system (example: on a boat or places
using power supplied from electric generator, etc.).
"A"
Sea breeze
Sea
Outdoor Unit
Outdoor Unit
Protection wall