Operating Instructions; Cautions; Cleaning And Maintenance - Profi-pumpe Solar Aqua-Vital 9-UV-C Operating Instructions Manual

6. OPERATING INSTRUCTIONS

Once installed, allow the control box to charge at least eight hours in direct sunlight or 8 hours by
adapter in order to fully charge the Battery.
3.1 Press the "on/off" button, turn on/off the system. The "L4" indicator light is on.
„L4" light will show battery four different status as below:
● Green blink, means the battery is full, pump can operate around 4 hours max.
● Yellow blink, means the battery is half, pump can operate around 1.5-3 hours max.
● Red blink. means the battery is almost running out, pump can operate around 0.5-1.5 hours max.
● Red blink, means the battery is dying, pump doesn't operate, need to charge it at once.
3.2 Press the "UV&Pump" button, the "L1" Green indicator light is blinking, pump and UV light will
operate in 2/3/4 hours by pressing 1/2/3 times of this button, then the pump and UV light will shut
down, "L1" Green indicator light turn to solid, the system will store this time in its memory and will
turn on every day at set time.
3.3 Press the "UV" button, the "L2" Green indicator light is blinking, UV light will operate in 2/3/4
hours by pressing 1/2/3 times of this button, then UV light will shut down, "L2" Green indicator light
turn to solid, the system will store this time in its memory and will turn on every day at set time.
3.4 Press the "Pump" button, the "L3" Green indicator light is blinking, pump will operate in 2/3/4
hours by pressing 1/2/3 times of this button, then the pump will shut down, "L3" Green indicator light
turn to solid, the system the system will store this time in its memory and will turn on every day at set
time..
Charging: Once connected the solar panel with the control housing, and placed the solar panel in
direct sunlight, the system is ready for charging. Customer can also use the adaptor to charge the
housing IN DOOR.

7. CAUTIONS

● Any altering of the product itself or changing of the components is forbidden.
● Do not connect the pump to any AC voltage power, it's ONLY for DC Voltage power.
● Operate in freshwater only (never above 45°C), especially keep away from flammable liquids.
● Do not strike the solar panel.
● Do not let the pump run dry for long time.

8. CLEANING AND MAINTENANCE

● If after some time the pump starts losing power or stops working, please clean up sediment in the
pump shell. Please note the pump can be opened by pressing down on the bottom of the filter
housing.
● To clear the impeller, open the pump housing by unscrew the front plastic cover.
The solar module should only be cleaned with soft tissue or propriety glass cleaning solution.
English 5