Dell Latitude D830 Service Manual page 2

packaging.
NOTE: If the new hard drive already contains the bezel, skip steps 3 - 5.
1 screws (2) on sides of hard drive bezel
3. Remove the two M3 x 5-mm screws from the sides of the hard drive bezel and pull the bezel
off the hard drive.
4. Remove the new drive from its packaging.
Save the original packaging for storing or shipping the hard drive.
5. Slide the hard drive bezel that you took off the old hard drive onto the new hard drive and
fasten the two M3 x 5-mm screws on the sides of the bezel.
NOTICE: Use firm and even pressure to slide the drive into place. If you use excessive force,
you may damage the connector.
6. Slide the new hard drive into the bay and into the connector until it is fully seated.
7. Replace the two M3 x 3-mm hard drive screws.
Back to Contents Page
2 hard drive bezel 3 hard drive