Setup; Stand Mounting - ION TOTAL PA TITAN User Manual

SETUP

Stand Mounting

Note: Speaker stand not included, sold separately.
1. Fully extend the speaker stand tripod legs on a flat, stable surface.
2. Raise the mounting pole up to the appropriate height needed and tighten the side
adjustment knob.
3. Insert the pin into the bottom pin-hole so the mounting pole stays at your set height.
4. On the Total PA™ Titan, adjust the bottom knob counter-clockwise so the screw is not
blocking the opening.
5. Line up the Total PA™ Titan mounting hole with the speaker stand pole and place on the
pole.
6. Tighten the mounting knob clockwise on Total PA™ Titan to secure it to the pole.
1
ION Audio Total PA™ Titan User Guide
3
2
4
5
6
4