Page 1
ITEM #05535031 18’x20’ Car Shelter MODEL #05535031 ATTACH YOUR RECEIPT HERE PROJECT SOURCE and logo design are trademarks or registered trademarks of LF, LLC. All rights reserved. Serial Number Purchase Date Questions, problems, missing parts? Before returning to your retailer, call our customer service department at 866-389-8827.
TABLE OF CONTENTS Package Contents...........................3 Hardware Contents..........................4 Safety Information..........................5 Preparation ............................5 l l a ......
PACKAGE CONTENTS PART DESCRIPTION QUANTITY PART DESCRIPTION QUANTITY Elastic+S-Hook Ground Anchor Corner Arch Center Arch Nail M6 x 45 Bolt Female Door Rail Male Door Rail M6 x 75 Bolt M6 x 100 Bolt Diagonal Bar Female Brace Wing Nuts Plastic Caps Male Brace T-Bar...
IMPORTANT: VENDOR REPRESENTS, WARRANTS AND AGREES THAT LABELING, DESIGN, PACKAGING, SPECIFICATIONS SHALL COMPLY IN ALL RESPECTS WITH ALL APPLICABLE LAWS AND STANDARDS. SAFETY INFORMATION Please read and understand this entire manual before attempting to assemble, operate or install the product. This winter car shelter is designed specifically to provide vehicle shelter from the elements during winter months.
Page 6
ASSEMBLY INSTRUCTIONS 1. Take a center arch (C) and insert a corner arch (B) at each end. Secure the male and female door rail (D) and (E) to the corner arch (B) along with the bar brackets (J). Slide the rail hooks (K) over the door rails before connecting them to the center arch using the T-bar (I)&...
Page 7
ASSEMBLY INSTRUCTIONS 3. At this point lift the front or back assembled frame and add 7 female braces (G). Then lift up another frame and add 7 male braces (H). Connect the first and second frame along with diagonal bar (F). For the remaining frames use the female braces (G).
Page 8
ASSEMBLY INSTRUCTIONS 6. Tie all the ties around the bars. Take the straps and pass them underneath the bars, pull up and tighten through each metal buckle. 7. Use (L) elastics and S hooks to close the door. Hardware Used Elastic+S-Hook x 24 8.
CARE AND MAINTENANCE -Never allow snow or ice build-up on the roof. Remove ice and snow with a broom or non-sharp snow removal tool, always from the outside of the structure. -Closing the doors at both ends will prevent wind accumulation inside the unit and will avoid movement concerns and/or undue strain or damage to your canopy and/or its structure.
Page 10
ARTICLE #05535031 Abri d’auto de 5,48 m x 6,09 m MODÈLE #05535031 JOIGNEZ VOTRE REÇU ICI PROJECT SOURCE et le logo sont des marques de commerce ou des marques de commerce déposées de LF, LLC. Tous droits réservés. Numéro de série Date d’achat...
Page 11
TABLE DES MATIÈRES Contenu de l’emballage........................3 Quincaillerie incluse..........................4 Consignes de sécurité ........................5 Préparation ............................5 Instructions pour l’assemblage ou l’installation ....
CONTENU DE L’EMBALLAGE PIÈCE DESCRIPTION QUANTITÉ PIÈCE DESCRIPTION QUANTITÉ Montant Élastique et crochet en S Ancre Arche de coin Arche centrale Clou Boulon M6 de 45 mm Rail de porte femelle Rail de porte mâle Boulon M6 de 75 mm Boulon M6 de 100 mm Barre diagonale Traverse femelle...
QUINCAILLERIE INCLUSE (grandeur réelle) Support de barre Élastique et crochet en S Grand crochet de rail de porte Qté : 10 Qté : 24 Qté : 24 Ancre Clou Boulon M6 de 45 mm Qté : 4 Qté : 8 Qté...
IMPORTANT: LE FOURNISSEUR REPRÉSENTE, GARANTIT ET ACCEPTE QUE L’ÉTIQUETAGE, LA CONCEPTION, L’EMBALLAGE ET LES SPÉCIFICATIONS SONT CONFORMES EN VERTU DE TOUTES LES LOIS ET NORMES APPLICABLES. CONSIGNES DE SÉCURITÉ Assurez-vous de lire et de comprendre l’intégralité du présent manuel avant de tenter d’assembler, d’installer ou d’utiliser l’article.
Page 15
INSTRUCTIONS POUR L’ASSEMBLAGE 1. Prenez une arche centrale (C) et insérez une arche de coin (B) à chaque extrémité. Fixez les rails de porte mâle et femelle (D) et (E) à l’arche (B) avec les supports de barre (J). Glissez les crochets de rail (K) sur les rails de porte avant de les relier à...
Page 16
INSTRUCTIONS POUR L’ASSEMBLAGE 3. À ce stade, soulevez l’armature assemblée avant ou arrière et 3 ajoutez 7 traverses mâles (G). Soulevez ensuite une autre armature et ajoutez 7 traverses femelles (H). Reliez la première et la deuxième armature avec les diagonales (F). Pour les autres armatures, utilisez les traverses femelles (G).
Page 17
INSTRUCTIONS POUR L’ASSEMBLAGE 6. Attachez toutes les attaches autour des barres. Prenez les courroies et passez-les sous les barres, tirez et serrez dans chaque boucle en métal. 7. Utilisez les élastiques et les crochets en S pour fermer la porte. Quincaillerie utilisée Élastique et crochet en S x 24...
ENTRETIEN -Ne laissez jamais la neige ou la glace s’accumuler sur le toit. Enlevez la glace et la neige avec un balai ou un outil de déneigement non tranchant, toujours de l’extérieur de la structure. -La fermeture des portes aux deux extrémités empêchera l’accumulation de vent à l’intérieur de l’article et évitera des problèmes de mouvement ou une contrainte et des dommages excessifs à...