Operation; Paper Jam And Motor Overload - Titanium 512XN Operating Manual

5. Operation

With the lid open, basket inserted, plug connected and switch in
AUTO position, the shredder is ready for use.
By introducing the sheets into the special mouthpiece, the process
of destroying the sheets will automatically start and stop working
once the fragmentation of the sheets has finished.
To destroy small materials such as envelopes, receipts or credit
cards, insert them in the center of the entrance.
On the top of the shredder there are also REV (reverse), FWR
(forward), OFF and READY.
1. The REV (reverse) command allows the motor to reverse the
motor in the event of a paper misfeed, thus releasing the blades
from the misfed paper.
2. The FWR (forward) command returns the motor to normal
operation after using the REV command. When switching from
REV to FWR position always allow the motor to stop to avoid
damage to it.
3. By placing the switch in the OFF position and closing the
top cover the shredder is no longer operational. It is strongly
recommended to switch off the shredder when you do not
intend to use it for a prolonged period.
4. When the READY light is on, the bin is correctly inserted and the
shredder is ready for use. If the READY light is off, make sure that
the plug is connected, that the basket is correctly inserted and
that the top cover is completely open.

paper jam and motor overload

512XN is equipped with a motor overload or overheating
protection system. The power supply will end in the following
abnormal situations:
1. in case of introduction of the maximum capacity of 12 sheets for
a prolonged period;
16
512XN