Table of Contents
Advertisement
Back to Contents Page
Processor Heat Sink
Dell™ Inspiron™ N3010 Service Manual
Removing the Processor Heat Sink
Replacing the Processor Heat Sink
WARNING:
practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.
WARNING:
CAUTION:
surface (such as a connector on your computer).
CAUTION:
is not covered by your warranty.
CAUTION:
computer.
Removing the Processor Heat Sink
1. Follow the instructions in
2. Follow the instructions from
3. In sequential order (indicated on the processor heat sink), loosen the seven captive screws that secure the processor heat sink to the system board.
1
processor heat sink
4. Lift the processor heat sink off the system board.
Replacing the Processor Heat Sink
NOTE:
This procedure assumes that you have already removed the processor heat sink and are ready to replace it.
NOTE:
The original thermal pad can be reused if the original processor and heat sink are reinstalled together. If either the processor or heat sink is
replaced, use the thermal pad provided in the kit to ensure that thermal conductivity is achieved.
1. Follow the instructions in
2. Place the processor heat sink in position.
3. In sequential order (indicated on the processor heat sink), tighten the seven captive screws that secure the processor heat sink to the system board.
4. Turn the system board assembly over.
5. Follow the instructions from
Great user manuals database on
Before working inside your computer, read the safety information that shipped with your computer. For additional safety best
If you remove the processor heat sink from the computer when the heat sink is hot, do not touch the metal housing of the heat sink.
To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal
Only a certified service technician should perform repairs on your computer. Damage due to servicing that is not authorized by Dell™
To help prevent damage to the system board, remove the main battery (see
Before You
Begin.
step 2
to
step 16
in
Removing the System
2
captive screws (7)
Before You
Begin.
step 7
to
step 21
in
Replacing the System
UserManuals.info
Removing the
Battery) before working inside the
Board.
Board.
Advertisement
Table of Contents
