Table of Contents
Advertisement
1
4
•
Do not clean the drain filter if the water in the appliance is hot.
•
Regularly check the drain pump filter and make sure that it is clean.
•
Make sure that the impeller of the pump can rotate. If it does not rotate, contact the Au-
thorised Service Centre. Make sure also that you tighten the filter correctly to prevent leak-
ages.
CLEANING THE INLET HOSE AND THE VALVE FILTER
1
1
2
3
FROST PRECAUTIONS
If the appliance is installed in an area where the
temperature can be less than 0 °C, remove the
remaining water from the inlet hose and the drain
pump.
Do this procedure also when you want
to do the emergency drain.
1. Disconnect the mains plug from the mains
socket.
2. Remove the water inlet hose.
3. Remove the drain hose from the rear support
and unhook it from sink or spigot.
4. Put the ends of the drain and inlet hose in a
container. Let the water flow out of the hoses.
2
5
2
3
3
5. Set any selected programme with option Spin/
Drain and let it operate until the end of the
cycle.
6. When no more water flows, install the inlet
hose and the drain hose again.
7. Press the On/Off button to deactivate the
appliance.
WARNING! Make sure that the
temperature is more than 0°C before
you use the appliance again. The
manufacturer is not responsible for
damages caused by low temperatures.
4
O
O
90
90
19
Advertisement
Table of Contents
