Advertisement
Fig. 4
Zoom Head Installation
1. Insert the Colposcope head into the focusing mount (Fig. 5).
2. Tighten the locking screws (Fig. 5).
3. Insert the eyepieces into the eyepiece tubes of the binocular or trinocular head (Fig. 6).
4. Screw the objective lens clockwise onto the bottom of the Colposcope head (Fig. 7).
Fig. 7
Fig. 5
Fig. 6
Arm Tension Adjustment
The Colposcope arm tension is adjusted and tested prior to leaving the factory. The arm may
be moved into any position and will hold its position. The suspension system is factory set to
assure the stability of the instrument. Arm adjustment should not be needed. If necessary,
further adjustment may be done following the procedures below.
To tighten up / down motion of the arm
1. Find the set screws labeled "A" on the picture in (Fig. 8). With an Allen wrench, turn the
screw clockwise in small steps to set the arm movement to desired tension.
2. All set screws should be tightened in the same manner.
5
Advertisement
