Page 1
(Original Instructions) HAVA1500ELEC Electric Pallet Truck Rev. 20220531 Haklift Oy Asessorinkatu 3-7 20780 Kaarina, Finland Tel. +358 2 511 5511 Lifting Solutions Group sales@haklift.com Axel Johnson International www.haklift.com...
Page 2
INSTRUCTIONS LOADING INSTRUCTIONS AND PRECAUTIONS INSTRUCTIONS TO REPLACE MAIN …………... COMPONENTS USE GUIDE INSTRUCTIONS For safety and correct operation of the pallet truck, please read this manual carefully (with understanding) before using the product. Incorrect use may lead to accidents. The product shall be assembled, used and maintained only by a competent and trained person.
Page 19
RELIEF HANDGRIP Press down on the handgrip and press down on the handle to lift the pallet truck; Lift up the handgrip and the forks will lower down; The handgrip is in the middle and the pallet truck is in the driving position.
Page 24
WARNING! 1. Users must check and do maintenance on a regular 8. Check and maintain the hydraulic system regularly. basis. Ensure no oil leak of the cylinder, hydraulic valve and 2. Rules of parking: other hydraulic system parts. - No parking on a ramp. 9.
Page 26
1. Ambient temperature 0-45 ° C, prohibit cold storage use; 2. Hard ground, flat, no sharp surface objects; 3. Prohibited to use in in heavy dusty environment; 4. Prohibited to cross water, oil and muddy ground; 5. Prohibited to caught in the rain, 10 minutes use in light rain;...
Page 27
The truck is not suited to lifting or carrying persons on the forks.
Page 30
(FULL ELECTRIC) 1. Handle numbers correspond to chassis numbers. 2. Disconnect the battery. 3. Remove handle shaft (item 2) from Handle socket. 4. Put the chassis connector through wire supporting plate (item 5) and lock hole. 5. Install handle assembly (item 1) to handle socket. Be careful to avoid damaging the wire harness.
Page 31
(SEMI-ELECTRIC) 1. Handle (Picture No. 1), match the holes of handle and hydraulic system. 2. Handle pins (Picture No. 2), the spring safety pin should be well rested in the holes situated on each side of the pump housing. 3. Chain (Picture No. 4) chain should be passed through the middle side hole of the handle pin and connected with the pump housing.
Page 32
BATTERY PROTECTION STOPPER 1. Put in the battery, rotate the anti-jumping stopper INSTALLATION INSTRUCTION against the battery and tighten the screw. 2. Loosen the screw and rotate the anti-jumping 1. Take out the screw (#1), block (#2) and washer (#3) stopper in the opposite direction, and pull out the in the manual bag and combine these three items battery vertically.
Page 51
INSTRUCTIONS 1. The battery is prohibited to charge in less than 0 degrees Celsius otherwise it will cause serious battery recession, or even a security incident. 2. The battery is prohibited to charge at low temperatures, but can use in not less than -20 degrees Celsius environ- ment.
Page 52
Usage environment Capacity ≥95% 55℃ ≥100% 25℃ ≥50% -10℃ Note: Although the battery can be discharged at very low temperatures, but the process of taking battery out is easy to produce condensate water droplets, which will break the battery internal electronic devices and cause unpredictable dangers.