Advertisement
N68-22 Cabinet Installation Guide
6.
7.
8.
Step 8 Unpack the carton, as shown in
Figure 3-5 Unpacking a carton
1 Carton label
4 Foam plate
1.
2.
3.
4.
Step 9 Unpack boards.
l Electronic components are extremely sensitive to static electricity. When unpacking the
l The ESD bag contains desiccant to keep the bag dry. When taking the board from a cold dry
1.
2.
Issue 01 (2013-01-30)
CAUTION
This operation needs three to five installers. Prevent the cabinet from falling during the
erection to avoid personnel injury.
Remove the bottom of the case, that is, the side with the wooden frame.
Remove the packing foam from the corners and edges of the cabinet.
Remove the vacuum plastic bag.
Check the types and quantities of the items in the carton according to the carton label.
Use diagonal pliers to cut the straps.
Rip the tape along the joint seams by using the paper knife. Do not insert the knife too deep,
or else the items may be damaged.
Unpack the carton and take out the items.
CAUTION
boards, wear an ESD wrist strap or a pair of ESD gloves properly.
place to a hot damp place, wait at least 30 minutes before unpacking. Otherwise, moisture
condensed on the board surface may damage the board.
Check that no evident damage is on the board packages.
Open the packages and ensure that the boards are in good condition. For any board problem,
contact the order management engineer at the local Huawei office.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
3 Preparing for the N68E-22 Cabinet Installation
Figure
3-5.
2 Strap
5 Board label
3 Pressure-sensitive tape
6 Board
11
Advertisement
