Pc Mode - JVC InteriArt LT-20E50SJ Instructions Manual

PC Mode

Installation
• Power off both Computer and Display before
making any connections.
• Set your PC’s resolution correctly before con-
necting to the TV. See the table in
supported modes.
• Use a D-SUB cable to connect the TV's PC
input to the computer's RGB output terminal.
If you want to listen to the sound from the
computer, use an audio cable to connect the
PC AUDIO IN to the computer's sound out-
put terminal.
$ÃQvÃHvvÃ9TˆiÃ8‚rp‡‚…
• Tighten the screws of the Display cable until
the connectors are fastened securely (fin-
ger-tighten only).
Main Menu in PC mode
Enter the main menu by pressing the “MENU”
button on the remote control.
PC Picture Position Menu
In the Main menu, select “PC Picture Posi-
tion” using “ “ or “
menu pressing “ “ / “ ” or “OK” buttons..
page 29
” button, then enter the
ENGLISH - 22 -
Auto Position
If you shift the picture horizontally or vertically
to an unwanted position, use this item to put
the picture into correct place automatically.
• Select Auto position item by using “
“ ” buttons.
for
• Press “OK” button.
• Press “MENU” button or “BACK” button to store
the value.
Warning: Auto position adjustment recom-
mended to be done with the full screen image
for the proper adjustment.
Horizontal Position
This item shifts the image horizontally to right
hand side or left hand side of the screen.
• Select Hori. Position item by using “
“ ” button.
• Use “ “ or “ ” button to adjust the value.
• Press “MENU” button or “BACK” button to store
the value.
Vertical Position
This item shifts the image vertically towards
the top or bottom of the screen.
• Select Ver. Position item by using “
“ ” button.
• Use “ “ or “ ” button to adjust the value.
• Press “MENU” button or “BACK” button to store
the value.
Dot Clock
Dot Clock adjustments correct interference
that appear as vertical banding in dot inten-
sive presentations like spreadsheets or para-
graphs or text in smaller fonts.
• Use “ “ or “ ” button to adjust the value.
Clock Phase
Depending on the resolution and scan fre-
quency that you input to the TV Set, you may
see a muddy or noisy picture on the screen. In
such a case you can use this item to get a
clear picture by trial and error method.
• Use “ “ or “ ” button to adjust the value.
“ or
“ or
“ or