Memory Upgrade Module - Optima Centoris W100 User Manual

3. Using Your Notebook PC
3-5

Memory Upgrade Module

Your notebook PC comes with either 128MB or 256MB of high speed Synchronous
Dynamic RAM (SDRAM) factory installed. To increase your notebook's memory
capacity, you may install an additional memory upgrade module. The memory upgrade
must be a dual-in-line (DIMM) SDRAM module.
CAUTION
3-5-1 INSTALLING A MEMORY UPGRADE MODULE
To install a memory upgrade module follow these steps:
WARNING
1. Turn off power to your notebook PC using the power switch, and remove any
power adapter.
2. Place your notebook PC upside-down on a clean work surface.
3. Open the top cover all the way, so that it is lying flat on the work surface.
4. Remove the screw holding the memory compartment cover.
CAUTION
48
Do not remove any screws from the memory upgrade module
compartment except the one specifically shown in the directions
for installing and removing the memory upgrade module.
You must turn off power before installing the memory upgrade
module.
The memory
upgrade module can
be severely damaged
by electrostatic
discharge (ESD). Be
sure you are
properly grounded
when handling and
installing the module.