System Upgrade; Memory Upgrade; Installing Memory Module - Optima Centoris V260 User Manual

Optima centoris v260: user guide
Table of Contents

Advertisement

System Upgrade

This section provides some steps in doing system upgrade for your notebook computer. The upgrade procedures include the
following:

7.1 Memory Upgrade

Your notebook computer offers 200-pin SODIMM (Small Outline Dual Inline Memory Module) at least 256MB DDR2 SDRAM.
The memory compartment is located inside your computer. The table below lists the possible combinations of different memory
module and memory size.
+
Please contact dealer for changing or adding DDR2 SDRAM module. It is not available for users to change it by themselves.
Based Memory
256 MB
256 MB
256 MB
256 MB
512 MB
512 MB
512 MB
512 MB
1024MB
1024MB
1024MB
1024MB

INSTALLING MEMORY MODULE

Your computer comes with standard 256 MB, 512MB or 1024MB of synchronous DDR2 SDRAM. You can increase system
memory to a maximum of 2048 MB in the system, by installing two small outline double inline memory modules (SO-DIMMs) with
installed base memory in the system.
The 256MB, 512MB and 1024MB memory modules are available:
To install the memory module:
1.
Make sure the system is powered off, the battery also is removed and that no peripheral devices are attached.
2.
Turn the computer upside-down and locate the screw that secures the DIMM door at the underside of the notebook.
3.
Remove the screws and open the DIMM cover by your finger.
4.
Locate the memory module into the empty memory module sockets. (Your system comes with one memory module already
installed in the socket.)
+
Avoid touching the exposed components inside the system. Doing so may damage the system.
5.
Insert the connector of the memory module into the socket. Make sure the notch of the memory module fits the nose of the
socket.
    Hold the memory module at a 30-degree angle and push its      connector into the memory socket of the notebook.
    Press down on the edge of the memory module until the locking
      tabs on both sides is locked.
6.
Put the DIMM door back and secure the screw on the DIMM door.
Installing Memory
0 MB
256 MB
512 MB
1024 MB
0 MB
256 MB
512 MB
1024MB
0 MB
256 MB
512 MB
1024MB
Total
256 MB
512 MB
768 MB
1280 MB
512 MB
768 MB
1024 MB
1536 MB
1024 MB
1280 MB
1536 MB
2048 MB

Advertisement

Table of Contents
loading

Table of Contents