Charging; Operation - Dexter Laundry 3.6VSD2.51 Legal And Safety Instructions

Note:
-
The declared vibration total value and the declared noise emission value have been measured in accordance with a standard test
method and may be used for comparing one tool with another.
- The declared vibration total value and the declared noise emission value may also be used in a
preliminary assessment of exposure.
- avoid vibration risk
suggestion: 1) wear glove during operation
2) limit operating time and shorten trigger time

7.CHARGING

.
The tool must be charged prior to the rst start-up.
. .
Connect the charger cable to the charging port on the bottom of machine and plug the charger into an appropriate outlet(230V), the red light
on the charger will be on.
. . When charging is completed, the light on the charger will turn to green. The machine is now fully charged.
Normally it will take 3-5 hours to fully charge the machine.
During the charging procedure, the handle of the machine warms up, this is normal.
Unplug the plug after charging
NOTE:
If the tool is hot, allow it to cool to ambient temperature before charging. To prevent damage to the battery, charge the battery to at least a
half-charge before storing. If the tool will not be used for long periods of time, charge the tool every 3-6 months.

8. OPERATION

.
Inserting bits-Insert the screwdriver bit directly into the hexagon collects, it will be held automatically by the suction
.
Removing bits-Pull out rmly the screw driver bit
Note:
Do not use double-sided screwdriver bits that are longer than 25mm.
The screwdriver has a built-in LED light to illuminate the work area and improve vision when working in areas with insu cient light. The LED
light will be automatically turns on while depressing the on
.
To switch on the tool, press the on/o switch
.
To switch
Change the bit
LED light
On/o switch
the tool, release the on switch
switch.
RU
KZ
EN