Table of Contents
Advertisement
en.haiwell.com
The default address of the Module is 1 with format 19200, N 82 RTU, and the online success is as follows:
If there is only one plc on the 485 port, then you can use "find standalone". If there are many, set the start address and stop
address, so that all the machines on the 485 port can be found and the parameters are configured. Click exit to enter the
configuration interface.
In the communication parameter area, we can change the Module's name, address, baud rate and data format and other
Haiwell PLC - Load Cell Module Application Example
20 /
24
Advertisement
Table of Contents
