Table of Contents
Advertisement
Filling the Tank
Remove powered sprayer head
WARNING
from
cleaning.
Follow
instructions for mixing, use, and handling of
chemicals. Always fill the tank with water first,
before adding chemicals.
1. Remove battery pack.
2.
Remove the tank from the powered sprayer head
and set on a level surface away from the
powered sprayer head to prevent exposure to
harsh chemicals.
3.
Unscrew and remove
the tank cap; ensure
strainer is seated in
opening. A removable
strainer prevents de-
bris from entering the
tank that can clog or
damage the pump.
4. Fill the tank. Use the
volume markings on
the side of the tank as
a guide.
5. Reinstall the tank cap.
6.
Reinstall the tank,
securing the tank latches.
7. Label tank contents accordingly during each use.
Only put recommended liquids in tank.
Installing the Tank
1. Remove battery pack.
2.
Secure tank to the powered sprayer head with
front and back tank latches; ensuring the
powered sprayer head is firmly seated, and all
seals are aligned.
OPERATION
To reduce the risk of injury,
WARNING
always wear personal protective
equipment (PPE) according to the chemical
manufacturer's
instructions.
proper eye protection marked to comply with
AS/NZS 1337.1.
Fuel Gauge
To determine the amount of charge left in the
battery, turn the tool ON. The Fuel Gauge will light
up for 2-3 seconds. When less than 10% of charge
is left, 1 light on the fuel gauge will flash 4 times.
To signal the end of charge, 1 light on the fuel
gauge will flash 8 times and the tool will not run.
Charge the battery pack.
If the battery becomes too hot, the fuel gauge lights
will flash and the tool will not run. Allow the battery
to cool down.
Adjusting the Flow Rate
Select the desired flow from Low (1) to High (3),
depending
on
the
manufacturer's instructions.
Setting
1
2
3
tank
before
filling
chemical
manufacturer's
Always
job
and
the
Pressure
Flow Rate
Low
0.38 LPM
Medium
0.76 LPM
High
1.14 LPM
To avoid accidental spraying, engage the trigger
or
lock-off.
Trigger
1.
Push down the lock-off at the end of the trigger.
2.
Hook the lock-off tab under the trigger.
3. To release, push the lock-off tab back into the
trigger, and unhook.
Turning the Sprayer ON/OFF
1.
Before turning ON, check for any leaks around
the
tank,
components before use.
2. To turn the sprayer ON, press the power button.
3 To start the flow of liquid at the spray wand, press
the trigger. The sprayer may be operated with
trigger handle attached to carrying handle.
4. To stop the flow of liquid at the spray wand,
release the trigger.
5. To turn the sprayer OFF, press the power button
again.
NOTE: Be aware some spray material may remain
inside the spray wand and drip out. To drain, turn off
the tool, then pull the trigger and point the tool down
until dripping stops.
•Pull the trigger and begin sweeping the nozzle from
side to side, coating the desired surface evenly in ac-
cordance with chemical manufacturer's instructions.
wear
NOTE: Make sure to stand far enough from the object
being sprayed to prevent the spray from splashing
chemical
back onto you.
•Always empty, clean, and drain the tank after every
use as directed in the Maintenance section.
•Thoroughly clean the sprayer before storing or
wash your hands and any area where skin has been
exposed to the spray.
6
Trigger Lock-Off
spray
wand,
hose,
Spraying
and
other
Advertisement
Table of Contents
