Do you have a question about the MS836 and is the answer not in the manual?
Questions and answers
Jackie Fry
January 21, 2025
how do i get it to recognize the starting zero in the upc example it scans 788808 for diet dr pepper but the code is 0788808 how do i change to recognize the zero.
1 comments:
Mr. Anderson
February 10, 2025
To configure the Unitech MS836 scanner to recognize the leading zero in UPC codes, follow these steps:
1. Scan the Enter Setup barcode to put the scanner in setup mode. 2. Scan the barcode for Transmit Lead Zero on UPC-E. 3. Scan the Exit Setup barcode to save the changes and exit setup mode.
Preface About This Manual Thank you for purchasing the Unitech product. This manual explains how to install, operate and maintain our product. No part of this publication may be reproduced or used in any form, or by any electrical or mechanical means, such as photocopying, recording, or information storage and retrieval systems, without permission in writing from the manufacturer.
Page 4
Use of other accessories may not ensure compliance with FCC RF exposure guidelines. European Conformity Statement Unitech Electronics co., Ltd herewith declares that the U nitech product is in compliance with the essential requirements and all other provisions of the RED 2014/53/EU directive.
Page 5
Waste electrical and electronic equipment (WEEE) Unitech has set up a policy and process to meet the 2012/19/EU concerning electronic waste disposal. For more detailed information of the electronic waste disposal of the products you have purchased from Unitech directly or via Unitech’s resellers, you shall either...
MS836 User’s Manual Laser Information The Unitech product is certified in the U.S. to conform to the requirements of DHHS/CDRH 21CFR Subchapter J and to the requirements of IEC 825-1. Class II and Class 2 products are not considered to be hazardous. The Unitech product contains internally a Visible Laser Diode (VLD) whose emissions do not exceed the maximum limits as set forth in the above regulations.
It may not be functional anymore. Please only use the original battery from Unitech. Using a third party battery can damage our products. Please note that when such damage occurs, it is not covered by Unitech’s warranty policy.
Unitech product for charging. Please remove the power adapter when the battery is fully recharged. The bundled power adapter that comes with your Unitech product is not meant to be used outdoors. An adapter exposed to water or rain, or a very humid environment can cause damage to both the adapter and the product.
MS836 User’s Manual Worldwide Support Unitech’s professional support team is available to quickly answer questions or assist with technical-related issues. Should an equipment problem occur, please contact the nearest Unitech regional service representative. For complete contact information please visit the Web sites listed below: Taipei, Taiwan –...
The warranty period is varied from each country. Please consult with your supplier or Unitech local office for actual length of warranty period to your purchased product. Warranty becomes void if equipment is modified, improperly installed or used, damaged by accident or neglect, or if any parts are improperly installed or replaced by the user.
MS836 User’s Manual Chapter 1 - Overview 1.1 Package Please make sure the following contents are in the MS836 gift box. If something is missing or damaged, please contact your Unitech representative. The package contents (without cradle): MS836 Scanner ...
Need help?
Do you have a question about the MS836 and is the answer not in the manual?
Questions and answers
how do i get it to recognize the starting zero in the upc example it scans 788808 for diet dr pepper but the code is 0788808 how do i change to recognize the zero.
To configure the Unitech MS836 scanner to recognize the leading zero in UPC codes, follow these steps:
1. Scan the Enter Setup barcode to put the scanner in setup mode.
2. Scan the barcode for Transmit Lead Zero on UPC-E.
3. Scan the Exit Setup barcode to save the changes and exit setup mode.
This answer is automatically generated