Bang & Olufsen BeoLab 20 Service Manual page 30

4.6 Replacement of modules
- Gently tilt heat sink to lay on a plane surface
! Attention: cables
! Attention: cable to PCB48.3, NTC (Woofer)
- Open cable holders where needed
- Reconnect lense connector to 02.2P2
- Apply screw at standoff
! Attention: Use allen key with bald end
! Attention: Do not scratch the lens parts
- BeoLab 20 - seen from top - indicating cable
placement
- BeoLab 20 in service position 2
1x
2.5mm