Bang & Olufsen BeoLab 20 Service Manual page 29

BeoLab 20 in service position 2
+ 4.2 BeoLab 20 in service position 1
- Remove screws
- Gently lift out heat sink and tilt approximately
30°
! Attention cables
- Open cable holders
- BeoLab 20 - seen from top - indicating cable
placement
! Attention cables
- Move cable connected to PCB30, P3 to same
side as connector P3
- Release cables from cable holders
! Attention: Cable holders inside cabinet
12x
TX20
Cable
holders
Cable
holders
Replacement of modules 4.5