disturbance
Program duration change
changes during the
Washing process.
Water is not visible
in the drum
bar.
Drum jerks
Program start.
In the chamber
there is residual water
ser.
Vibrations and movement
the appliance during
spinning.
Drum turns,
Water does not run in.
Strong foaming
manure.
High spin speed
number is not
reached.
Cause and troubleshooting
The unbalance control system compensates for the unbalance
by distributing the laundry several times.
No mistake - no action required.
▶
Note: When loading, place large and small items of
laundry together in the drum. Laundry items of
different sizes are better distributed during spinning.
The foam control system switches on a rinse cycle if the
foam builds up too much.
No mistake - no action required.
▶
Water is below the visible range.
No mistake - no action required.
▶
Do not fill an additional one during operation
▶
Water into the device.
The cause is an internal motor test.
No mistake - no action required.
▶
The insert in the chamber is blocked.
loading
→ " Cleaning the detergent drawer ", page 58
▶
Device is not aligned correctly.
Align the device
▶
The feet of the device are not fixed.
Fix the device feet. Align the device
▶
Transport locks are not removed.
Remove the transport locks
▶
Load detection is active.
No mistake, no action necessary.
▶
Note: The load detection can take up to 2 minutes.
Detergent dosage is too high.
Immediate action: Mix one tablespoon
▶
Softener with 0.5 liters of water and pour the
mixture into the left compartment (not for outdoor,
sportswear and down textiles).
For the next wash cycle, reduce the
▶
load the amount of detergent.
The low spin speed is set.
Set a higher one for the next wash cycle
▶
Spin speed.
Easy iron is activated.
Troubleshooting de
67