Table of Contents
Advertisement
de Troubleshooting
disturbance
Detergent does not work Rinse hold
pumped out.
Water does not run in. Start pause
Detergent won't
washed in.
Repeated arrival
sling.
Program duration change
changes during the lead to a change in the program duration.
Washing process.
66
Cause and troubleshooting
Continue the program by pressing Sluice
▶
change or Pumping out choose and Start pause
to press.
→
"Continuing the program at Rinse Hold", page 51
The water drainage hose is connected too high.
Mount the water drainage hose in maxi-
▶
times 1 meter in height.
Pump cover is not assembled correctly.
Assemble the pump cover correctly.
▶
Detergent dosage is too high.
Immediate action: Mix one tablespoon
▶
Softener with 0.5 liters of water and pour the
mixture into the left compartment (not for outdoor,
sportswear and down textiles).
For the next wash cycle, reduce the
▶
load the amount of detergent.
Inadmissible extension mounted on the water
drainage hose.
Remove impermissible extensions from the water
▶
drain hose. Connect device
Press Start pause
▶
The filter in the water inlet is blocked.
Clean the filter in the water inlet → Page 63.
▶
The tap is closed.
Open the faucet.
▶
The water inlet hose is kinked or pinched.
Make sure that the water inlet hose
▶
is not kinked or pinched.
The unbalance control system compensates for the unbalance
by distributing the laundry several times.
No mistake - no action required.
▶
Note: When loading, place large and small items of
laundry together in the drum. Laundry items of
different sizes are better distributed during spinning.
The program sequence is electronically optimized. That can
No mistake - no action required.
▶
is activated.
was not pressed.
.
Advertisement
Table of Contents
