Table of Contents
Advertisement
5.
17.8 Clean the sieve in the
water inlet
Empty the water inlet hose
In order to be able to clean the sieve,
first empty the water inlet hose.
Turn off the tap.
1.
Set a program, except
2.
Rinse spin or Pump out.
Start the program and let it run for
3.
about 40 seconds.
Switch off the device.
4th
Disconnect the device's power plug
5.
from the power supply.
Clean the strainer on the tap
Note: Note the information on
security
→
page 4 and avoid damage to property.
the → Page 11, to use your device
safely.
Pre-condition: The water inlet hose
is empty.
Cleaning and care de
Remove the water inlet hose
1.
from the tap.
Clean the sieve with a small brush.
2.
Connect the water inlet hose and
3.
check for leaks.
63
Advertisement
Table of Contents
