Maxon BIKEDRIVE AIR Quick Start Manual

This Quick Start Guide for your BIKEDRIVE AIR makes no claim to completeness. For detailed infor-
mation on the individual functions, consult the Operating Manual or the
www.maxonbikedrive.com website.
POWERTAB

SWITCHING THE SYSTEM ON/OFF

Briefly press the On/Off button. When the system
starts up, no support level is active. The bike
behaves like a normal bicycle without support.
After the system startup, the On/Off button can be
used to switch the light on or off.

DISPLAYING THE SOC OF THE BATTERY

After startup, the state of charge (SOC) is continu-
ously displayed by LEDs. If all 7 LEDs are lit, the
battery is full.
If the indicator flashes, the battery is being
charged. If the battery charge is too low, no SOC is
displayed. Instead, the white Status LED is lit. Once
the battery charge gets too low, the bike switches
off automatically.

SWITCHING OFF

Press the On/Off button for approximately
5 seconds until the LED display turns off.

RIDE MODE

NO LED IS LIT
The motor support has been switched off. You can
cycle as usual.

POWERTAB FUNCTIONS

LEVEL I - II - III
The selected support level is displayed with three
bars. If no bar is lit, level Zero has been selected.
The bike does not provide any support.
As soon as you select a level, support is provided.
Level III provides the strongest support. The higher
the motor support, the lower the range.
Active Range
Extender
Status LED
Service LED
Error LED
Support levels: 0-I-
II-III
Decrease support
maxon BIKEDRIVE AIR | Quick Start Guide
Edition 2023-02 | Document ID 9473428-02
State of charge (SOC)
On/Off button
and light switch
Increase support
INDIVIDUALLY CONFIGURING THE SUPPORT
LEVELS WITH THE CONNECT APP
maxon offers a Connect app for iOS and Android.
With the Connect app, the rider can individually con-
figure the support levels and use the cell phone as a
display on the handlebar.
Connect Google Play
app Store

LED DISPLAY

WHITE (STATUS LED)
The white Status LED is continuously lit as soon as
the e-bike is switched on.
GREEN (ACTIVE RANGE EXTENDER)
When the green LED is on, an active Range
Extender has been detected.
BLUE (SERVICE LED)
When the service tool switches the e-bike to ser-
vice mode for diagnostics or system configuration,
the blue Service LED is lit. In this mode, the bike
does not provide any motor support.
RED (ERROR LED)
If the e-bike detects an error, the red Error LED
lights up.
To exit the fault condition, the e-bike must be
switched off and on.
© 2023 maxon. All rights reserved.
iOS App Store