ActiGraph CENTREPOINT Insight Watch User Manual page 8

Assignment
9.
Remove the CPW01 from the charging dock by pulling the plastic tab to the right and away from the CPW01. Wait for
the CPW01 to go from halt mode into active mode, as indicated by the running person icon in the upper left corner of
the screen. This takes approximately 90 seconds.
10.
Pair the CP Data Hub with the CPW01
(If you're not using a CentrePoint Data Hub, skip ahead to Information for Participants)
• Connect the adapter end of the power cable into the back of the CP Data Hub and plug the other end into a wall outlet.
• The blue LED status light on the back of the CP Data Hub will flash during startup. It may take up to 20 seconds for
the light to begin to flash. Once the CP Data Hub connects to the cellular network, the blue LED light will stay on solid.
• Connect the charging dock to the USB port on the CP Data Hub using the USB cable.
CENTREPOINT INSIGHT WATCH | E.200.6002 | RELEASED: 01/09/2023 | REV: 7
| Continued
Halt Mode
Stop icon will be displayed if
the CPW01 is not collecting
data.
USB Port Power Status Light
Active Mode
A running person icon will
be displayed if the CPW01 is
collecting data.
8
THEACTIGRAPH.COM